Table of Contents
Advertisement
Figure 34. Connecting an LC-LC cable into the LC-SC cable adapter
5. If you are connecting the DS4200 Express host port to a 1-Gbps fibre channel
switch or fibre channel host bus adapter, connect the SC connector end of the
LC-SC cable adapter to a Gigabit Interface Converter (GBIC) that is installed in
the 1-Gbps fibre channel switch or fibre channel host bus adapter. For more
information about connecting to these devices, see the documentation that
comes with the device.
Removing an LC-LC cable from an LC-SC cable adapter
Complete the following steps to remove an LC-LC cable from an LC-SC cable
adapter:
Attention:
To avoid damaging the LC-LC cable, make sure you press and hold
the lever to release the latches before you remove the cable from an LC-SC cable
adapter. Ensure that both levers are in the released position when removing the
cable. When removing the cable from the SFP module, make sure you do not grasp
the SFP module plastic tab.
1. On the end of the cable that connects into the LC connector end of the LC-SC
cable adapter, press down and hold the lever to release the latches. Figure 35
shows the location of the lever and latches.
Lever
Figure 35. LC-LC fibre-channel cable lever and latches
2. Carefully pull on the connector to remove it. Make sure you grasp the connector
and not the cable when removing the LC-LC cable from the LC-SC cable
adapter as shown in Figure 36 on page 54.
Latches
Chapter 3. Cabling the storage subsystem
53
Advertisement
Table of Contents
