Removing An Lc-Lc Cable From An Lc-Sc Cable Adapter; Lc-Lc Fibre-Channel Cable Lever And Latches; Removing The Lc-Lc Fibre-Channel Cable From An Lc-Sc Fibre-Channel Cable Adapter - IBM DS4800 User, Installation And Maintenance Manual

Removing an LC-LC cable from an LC-SC cable adapter

Complete the following steps to remove an LC-LC cable from an LC-SC cable
adapter:
Attention:
the lever to release the latches before you remove the cable from an LC-SC cable
adapter. Ensure that both levers are in the released position when removing the
cable. When removing the cable from the SFP module, make sure you do not grasp
the SFP module plastic tab.
1. On the end of the cable that connects into the LC connector end of the LC-SC
Figure 39. LC-LC fibre-channel cable lever and latches
2. Carefully pull on the connector to remove it. Make sure you grasp the connector
Figure 40. Removing the LC-LC fibre-channel cable from an LC-SC fibre-channel cable
adapter
3. Replace the protective caps on the cable ends.
58
IBM System Storage DS4800 Storage Subsystem: Installation, User's, and Maintenance Guide
To avoid damaging the LC-LC cable, make sure you press and hold
cable adapter, press down and hold the lever to release the latches. Figure 39
shows the location of the lever and latches.
Lever
Latches
and not the cable when removing the LC-LC cable from the LC-SC cable
adapter as shown in Figure 40.