Table of Contents
Advertisement
Guide pin
Figure 72. Installing a controller
b. As you slide the controller into the empty slot, make sure the guide pins on
the side of the controller fit into the notches. After the guide pins fit into the
notches and the controller fits snugly into the bay, push the lever downward
or upward 90°, depending on whether the controller is inserted in the A or
B controller bay to fully latch it into place. Do not force fit. The controller is
designed to prevent it from being inserted into the chassis incorrectly.
Attention:
Make sure that the levers lock into place in the storage
subsystem chassis.
c. Repeat step 11a on page 108 and step 11b to replace the second
controller.
12. Wait up to 5 minutes for the DS4000 Storage Manager client software to
recognize the new controller.
13. Complete any remaining Recovery Guru procedures for controller replacement,
if needed.
14. Check the LEDs on the new controller to verify that the controller is fully
operational.
15. Remove the antistatic protection.
16. Use the DS4000 Storage Manager client Subsystem Management window to
check the status of all components in the storage subsystem.
v If the new controller is online and the DS4000 Storage Manager client
Subsystem Management window indicates normal operation, go to step 19
on page 110.
v If the new controller is online and the DS4000 Storage Manager client
Subsystem Management window indicates a problem status, go to
"Troubleshooting the storage subsystem " on page 87.
v If the new controller is offline, go to step 17.
17. If the newly inserted controller is in an offline state, see the DS4000 Storage
Manager client online help for instructions on bringing the controller online.
Lever
Notch
Chapter 5. Replacing components
109
Advertisement
Table of Contents
