Table of Contents
Advertisement
Appendix B. Rack mounting template
This appendix provides duplicate copies of the rack mounting templates. If you want
to tear out the templates from this document for easier use, use these copies rather
than those provided in "Installing the support rails" on page 28.
Use the following templates (Figure 82 and Figure 83 on page 148) to identify the
proper locations for inserting M5 screws when mounting the support rails and
DS4200 Express to a rack. The locations for the M5 screws are highlighted in the
templates.
The DS4200 Express is 3 U high. Align the template with the rack at a U boundary.
U boundaries are shown as horizontal dashed lines in the rack mounting templates.
Note: The mounting holes that are shown in the following templates are square.
Install second --->
Install second --->
Figure 82. Front rack mounting template
© Copyright IBM Corp. 2006
The holes in your rack might be round or square.
3 U
(Front Left)
Install first --->
2 U
Install first --->
1 U
Rail assembly
0 U
DS4200 Express
FRONT
Bezel
Rack Mounting
Template
(Front Left)
3 U
Bezel
(Front Right)
<--- Install first
2 U
<--- Install first
1 U
Rail assembly
(Front Right)
0 U
147
Advertisement
Table of Contents
