Table of Contents
Advertisement
Figure 29. Inserting an LC-LC fibre-channel cable into an SFP module
5. Remove the two protective caps from the other end of the LC-LC cable. Save
6. Connect this end of the LC-LC cable to one of the following devices:
Removing an LC-LC fibre-channel cable
Complete the following steps to remove an LC-LC fibre-channel cable:
Attention:
you observe the following precautions:
v Press and hold the lever to release the latches before you remove the cable from
v Ensure that the levers are in the released position when you remove the cable.
v Do not grasp the SFP module plastic tab when you remove the cable.
1. On the end of the LC-LC cable that connects into the SFP module or host bus
Figure 30. LC-LC fibre-channel cable lever and latches
2. While pressing down the cable lever, carefully pull on the connector to remove
50
IBM System Storage DS4200 Express Storage Subsystem: Installation, User's and Maintenance Guide
the protective caps for future use.
v An SFP module that is installed in a separate EXP420 storage expansion
enclosure
v An SFP module that is installed in a fibre channel switch port
v A fibre channel host bus adapter port
To avoid damaging the LC-LC cable or SFP module, make sure that
the SFP module.
adapter, press down and hold the lever to release the latches, as shown in
Figure 30.
Lever
Latches
the cable from the SFP module, as shown in Figure 31 on page 51.
Advertisement
Table of Contents
