Table of Contents
Advertisement
CAUTION:
When laser products (such as CD-ROMs, DVD drives, fiber optic devices, or
transmitters) are installed, note the following:
v Do not remove the covers. Removing the covers of the laser product could
v Use of controls or adjustments or performance of procedures other than
DANGER
1. Read the information in "Handling fiber-optic cables" on page 44.
2. Connect one end of an LC-LC cable to an SFP module inserted in the DS4200
3. Remove the two protective caps from the LC connector end of the LC-SC cable
Figure 33. Removing the LC-SC cable adapter protective caps
4. Carefully insert the other end of the LC-LC cable into the LC connector end of
52
IBM System Storage DS4200 Express Storage Subsystem: Installation, User's and Maintenance Guide
result in exposure to hazardous laser radiation. There are no serviceable
parts inside the device.
those specified herein might result in hazardous radiation exposure.
Some laser products contain an embedded Class 3A or Class 3B laser
diode. Note the following.
Laser radiation when open. Do not stare into the beam, do not view directly
with optical instruments, and avoid direct exposure to the beam.
Express fibre channel host port. For instructions, see "Using LC-LC
fibre-channel cables" on page 48.
adapter as shown in Figure 33. Save the protective caps for future use.
the LC-SC cable adapter as shown in Figure 34 on page 53. Push in the
connector until it clicks into place.
Advertisement
Table of Contents
