Remove The Power Entry Module - Fluke 6270A Service Manual

Remove the Power Entry Module

To remove the power entry module, see Figure 27.
1. Use needle nose pliers to remove the brown , blue , and green  wires
from the power entry module on the back of the Product.
2. Turn the chassis over and use #1 Phillips screwdriver to remove the two M3 x
6 FH .
3. Pull out the power entry module .
Reverse these steps to replace power entry module.
Figure 27. Remove Power Entry Module
Pressure Controller/Calibrator
Power Supply and Fan
hxn223.eps
49