Coin Vault Switch - Whirlpool CHW9050 Service Manual

Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug washer or disconnect power.
2. Remove the service access door from the
metercase.
3. Remove the coin vault.
4. Disconnect the wire harness connector from
the switch in the service access area.
Service
Switch
NOTE: It is quite easy to incorrectly install
the Service and Vault Switch wire harness.
Mark the wires for the switch that they go to
prior to disassembly. This will make it much
easier to remember the correct orientation
and avoid a miss-wired issue.

COIN VAULT SWITCH

5. Squeeze the tabs on the top and bottom of
Coin Vault
Switch
4-50
the switch from inside the service access
area and push the switch into the coin vault
compartment.
NOTE: If the coin vault switch is not wired
or the coin box is not installed the washer
display will be flashing.