Door Hook; Door And Hinge Assembly - Whirlpool CHW9050 Service Manual

DOOR HOOk

1. Open the washer door.
2. Remove two T-20 screws that secure the
hook to the door.
Two T-20
Screws
3. Depress the locking tab. Lift and slide the
hook out of the slot in the door.
Locking
Tab
REASSEMBLY NOTE: When reinstalling
the door hook, do not tighten the hook
completely. The hook should remain loose
enough to move as it needs to center itself
when the door closes.
Locking
Tab
Hook
4-18
DOOR AND HINGE
ASSEMBLY
1. Open the washer door.
2. Remove two 1/4" hex head screws that
secure the hinge to the front panel.
Two 1/4"
Hex Head
Screws
3. Lift the door and hinge assembly up and pull
the hooks out of the slots in the front panel.