Whirlpool CHW9050 Service Manual page 73

9. The switch is attached to the top half of
the extension. Rotate the top half, from the
side, to remove the tab from the slot of the
bottom extension half.
Tab
Slot
10. To access spare inserts, remove Phillips
screw securing the retainer. There are spare
inserts with slots as well as blanks. Take
spare inserts out of the storage area.
Spare Blank
11. Turn the coin slide over and remove two
Phillips screws that secure the bottom half
of the extension to the coin slide.
Two Phillips
Screws
12. Turn coin slide back to the upright position
13. Take note of the ratchet key installed along
Switch
Spare Slot
14. There is a ratcheting tab on the bottom of
Phillips
Screw
4-47
and push the sliding portion of the assembly
out the front.
the edge of the slide. Make sure to reinstall
this piece during reassembly.
the slide that catches in the holes. During
normal operation, this keeps the slide from
being able to be pulled back out until it has
been slid all the way in.
Ratchet
Tab
Ratchet
Key
Ratchet
Key