Table of Contents
Advertisement
S
S
UPER
ERVER 5018A-TN4 User's Manual
Control Panel
Power Supply
Rear I/O Ports (see Figure 5-2)
6-2
Control Panel
The control panel (located on the front of the chassis) must be connected to the
JF1 connector on the motherboard to provide you with system status indications. A
ribbon cable has bundled these wires together to simplify the connection. Connect
the cable from JF1 on the motherboard to the Control Panel PCB (printed circuit
board). Make sure the red wire plugs into pin 1 on both connectors. Pull all excess
cabling out of the airflow path. The LEDs inform you of system status.
See Chapter 3 for details on the LEDs and the control panel buttons. Details on
JF1 can be found in Chapter 5.
Figure 6-1. Front and Rear Chassis Views
Low-profile PCI Slot
6-2
Advertisement
Table of Contents
