Memory Population Guidelines
Please follow the table below when populating memory slots.
DIMM Slots per
DIMMs Populat-
Channel
ed per Channel
2
2
Note: Use memory modules of the same type, speed, frequency and size.
Module Notch
5-6
Adding PCI Add-On Cards
The 5018A-TN4 can accommodate a single RSC-RR1U-E8 riser card to support
a PCI-E x8 add-on card
Installing an Add-on Card
1. Begin by removing the shield for the PCI slot where the riser card is located.
2. Fully seat the card into the riser card, pushing down with your thumbs evenly
on both sides of the card.
3. Finish by using a screw to secure the top of the card shield to the chassis.
The PCI slot shields protect the motherboard and its components from EMI
and aid in proper ventilation, so make sure there is always a shield covering
each unused slot.
Unbuffered DDR3 ECC SODIMM Memory
DIMM Type
Unbuffered
1
DDR3 SODIMM
Unbuffered
2
DDR3 SODIMM
Socket Key
Chapter 5: Advanced Motherboard Setup
POR Speeds
1600,1333
1600,1333
Module Key
5-5
Memory Population
Sequence
A1, B1 (2 DIMMs)
A1, B1, A2, B2
(4 DIMMs)
Module Notch