Table of Contents
Advertisement
Device Power-Up Delay
Use the feature to set the maximum time a USB device will wait before report-
ing itself to the host controller. Select Auto to use the manufacturer's default
setting. Select Manual to set the default setting manually. The default setting
is 20 seconds.
SATA Configuration
When this submenu is selected, the AMI BIOS automatically detects the presence
of the SATA Devices and displays the following items:
SATA 3 Controller
This feature allows the user to configure the settings of SATA 3.0 devices
SATA 3 Controller
Select Enabled to enable the onboard SATA 3.0 controller. The options are Enabled
and Disabled.
SATA Mode
This item sets SATA device mode. The options are IDE and AHCI.
LPM (Link Power Management)
Select Enabled to support Link Power Management to improve system power
management. The options are Disabled, and Enabled.
ALPM (Aggressive Link Power Management)
Select Enabled to support Aggressive Link Power Management to enhance
system power performance. The options are Disabled, and Enabled.
Overwrite SIR Values
Select Enabled to overwrite SIR values. The options are Enabled, and Disabled.
SATA Port 0/SATA Port 1
The submenu below allows the user to configure the following settings for SATA
Port 0 or SATA Port 1.
Spin Up
On an edge detect from 0 to 1, use this feature to set a COMRESET initialization
sequence for a device. The options are Enabled and Disabled.
7-17
Chapter 7: BIOS
Advertisement
Table of Contents
