Toshiba TECRA A8 series Maintenance Manual page 72

2 Troubleshooting Procedures
Procedure 2
Check the D port status by a debug port test. The tool for debug port test is shown below.
The test procedures are follows:
1. Connect the debug port test cable to the connector CN3490 of the system board. For
disassembling to connect the test cable, refer to Chapter 4.
2. Connect the debug port test cable and RS-232C cross-cable to the test board.
3. Connect the RS-232C Cross-cable to the PC that displays the test results.
4. Boot the computer in DOS mode.
5. Execute GETDPORT.COM in the text menu in CPU REAL mode. (Insert the FD for
starting D port into FDD and input "FD starting drive:>dport".)
The D port status is displayed in the following form;
6. When the D port status is FFFF (normal status), go to Procedure 4. When the D port
status falls into any other status than FFFF, go to Procedure 3.
2-24
Downloaded from www.Manualslib.com
Debugging Port Check (Boot Mode)
Figure 2-2 A set of tool for debug port test
[CONFIDENTIAL]
manuals search engine
2.4 System Board Troubleshooting
TECRA A8 /Satellite Pro A120 Maintenance Manual (960-573)