Toshiba Satellite A10 Maintenance Manual page 233

4.7 Fan Module/Cooling Fin/CPU
NOTE: Apply the silicon grease enough to cover the chip surface using the special
applicator. When installing the fin, make sure the bottom of the fin covers the top of CPU.
5. Install the cooling fin.
6. Place the CPU holder on the cooling fin with its holes (small and large) attached to
7. Connect the fan module cable to PJ8770 on the system board.
8. Install the fan module and fix it with the following screws.
9. Attach the CPU cover and fix it with the following screws.
Satellite A10/TECRA A1/Satellite Pro A10 Maintenance Manual (960-445)
Downloaded from www.Manualslib.com
Figure 4-18 Applying Silicon Grease
the bosses of the cooling fin. Fix the CPU holder with following screws in the order
of the marks (1 to 4) on the CPU holder.
• M2x6
• M2.5x5
• M2.5x5
• M2.5x16 THIN BIND screw
manuals search engine
CPU Chip
BIND screw
THIN BIND screw
THIN BIND screw
4 Replacement Procedures
x4
x2
x2
x1
4-27