Toshiba PORTÉGÉ A600 Maintenance Manual page 251

4.10 SD board
4.10 SD board
Removing the SD board
To remove the SD board, follow the steps below and refer to Figure 4-10.
1. Remove the following screws and lift up the SD board (Be careful that the SD board
2. Disconnect the SD board FPC from the connector CN9710 on the back of the SD
3. Disconnect the wireless LAN antenna cable, 3G antenna cable and antenna relay
PORTÉGÉ A600 Maintenance Manual (960-710)
Downloaded from www.Manualslib.com
FPC, wireless LAN antenna cable, 3G antenna cable and antenna relay cable are
connected to the connector on the back of the SD board).
• M2×3B
S-THIN HEAD
board.
cable from the connectors on the back of the SD board (only for antenna relay model).
Wireless LAN antenna cable
(black)
SD board
M2x3B S-THIN HEAD
Figure 4-10 Removing the SD board
manuals search engine
4 Replacement Procedures
×2
Antenna relay cable (blue)
3G antenna cable (blue)
SD board FPC
CN9710
(back of the SD board)
[CONFIDENTIAL] 4-23