Toshiba PORTÉGÉ A600 Maintenance Manual page 167

3.20 ONLY ONE TEST
Subtest 03
Subtest 04
NOTE: When executing this subtest, USB test module and USB cable must be connected.
################################################################
########
################################################################
*
*
*
*
*
*
****************************************************************
.... Press test number[0-2, 9] ?
PORTEGE A600 Maintenance Manual (960-710)
Downloaded from www.Manualslib.com
Wireless communication Switch
This subtest checks if the Wireless communication switch works properly.
If the test is started with the switch ON, following message appears in the
display.
Wireless communication Switch
position (OFF)
Slide the switch to OFF position. Then, following message appears in the
display.
Wireless communication Switch
Slide the switch to ON position. Then, following message appears in the
display.
Wireless communication Switch
After Sliding the switch to OFF position, return to the ONLY ONE TEST
menu automatically.
USB
This subtest checks if USB port works properly.
The following menu appears in the display.
Port Select menu
0 ............ Port 0 (Right side )
1 ............ Port 1 (Left side back)
2 ............ Port 2 (Left side front)
9 Exit
Connect the USB test module and USB cable to the computer.
Input the port test number and press Enter.
OK message appears in the display if the test ends without fail.
NG message appears in the display if an error is found during the test. Confirm
the connection of cable, and then execute the test again.
manuals search engine
3 Tests and Diagnostics
is set to a start
ON !!
OFF !!
[CONFIDENTIAL]
######
*
*
*
*
*
*
3-43