4 Replacement Procedures
4.16 MP FPC
Removing the MP FPC
To remove the MP FPC, follow the steps below and refer to Figure 4-23.
1. Remove the following screw and kill switch holder.
•
2. Remove the following screws and disconnect the MP FPC from the connector
CN9500 on the system board.
•
4-34
[CONFIDENTIAL]
M2×3C
S-FLAT HEAD screw
M2×3C
S-FLAT HEAD screw
Kill switch holder
M2×3C S-FLAT HEAD
Figure 4-23 Removing the MP FPC
x1
x2
MP FPC
CN9500
PORTEGE R200 Maintenance Manual (960-519)
4.16 MP FPC
M2×3C S-FLAT
HEAD