Removing The Mp Separation Pulley - Kyocera KM-2560 Service Manual

Removing the MP separation pulley

12. Reverse the MP unit and remove the spring
and stop ring from the MP separation pulley
shaft.
13. Move the bush inside.
14. Raise the MP separation pulley shaft.
Remove the holder plate and the bush, and
then remove the MP separation pulley.
Stop ring
Torque limiter
MP separation
pulley shaft
Bush
Spring pin
Gear 16
Spring
MP unit
MP separation
pulley shaft
MP separation
pulley shaft
Bush
Figure 1-5-15
Holder plate
Bush
MP separation
pulley
Figure 1-5-16
2H0/2HZ
1-5-9