Kyocera KM-2560 Service Manual page 294

2H0/2HZ-1
Maintenance
Section
part/location
Optical Laser scanner unit
section
Platen
Slit glass
Mirror 1
Mirror 2 and mirror 3
Lens
Reflector
Exposure lamp
Optical rail
Original size detection
sensor
Maintenance
Section
part/location
Transfer/ Transfer roller unit
separation
section
Separation electrode
Maintenance
Section
part/location
Developing Developing unit
section
2-4-4
Maintenance
Method
cycle
Clean Every service
Clean Every service
Clean Every service
Clean User call
Clean User call
Clean User call
Clean User call
Check or User call
replace
Check or User call
Grease
Check or User call
clean
Maintenance
Method
cycle
Replace 300K
Check or Every service
clean
Maintenance
Method
cycle
Replace 300K
Points and cautions
Clean the slit glass with a dry
cloth.
Clean with alcohol and then a dry
cloth.
Clean with a dry cloth or alcohol
(do not clean with a wet cloth).
Clean with a wet cloth and then a
dry cloth only if vertical black lines
appear on the copy image.
Clean with a wet cloth and then a
dry cloth only if vertical black lines
appear on the copy image.
Clean with a dry cloth only if verti-
cal black lines appear on the copy
image.
Clean with a dry cloth only if verti-
cal black lines appear on the copy
image.
Replace if an image problem
occurs.
Check noise and shifting and then
apply scanner rail grease EM-
50L.
Clean the sensor emitter and sen-
sor receiver with alcohol or a dry
cloth only if there is a problem.
Points and cautions
Replace. (Vacuum or clean with a
dry cloth when user call occurs.)
Clean with a cleaning brush.
Points and cautions
Replace. (Check and replace
when user call occurs.)
Page
P.1-5-30
P.1-5-15
Page
P.1-5-40
Page
P.1-5-39