Basic Operation; Selecting The Display Language; Factory Set (Initializing The Electone) - Yamaha Electone STAGEA ELB-02 Owner's Manual

3

Basic Operation

Selecting the Display Language

                                     
The LCD display can be shown in two languages, English and Japanese. The default
setting is English.
1
Press the [UTILITY] button on the panel.
The Utility display appears. Since the language is set in Utility display Page 1,
select Page 1 with the page buttons if another page is shown.
2
Press the [A] button to select the corresponding language then
successively press the same button to switch the value between
Japanese and English.

Factory Set (Initializing the Electone)

                                     
All current settings including Registration Memory (in all banks), Display language
and display contrast settings can be deleted at once by the following procedure. Be
careful when executing Factory Set, since it erases all your existing data. Always save
your important data to a USB flash drive.
Note that the operation here does not affect the settings of the wireless LAN settings,
which can be initialized on page 200.
1
Turn off the power.
NOTICE
The language setting is
automatically saved when
another display is called
up. Make sure to switch to
another display before
turning the power off.
Reference Page
Saving the Registration Data
to USB Flash Drive
(page 118)
Reference Page
Initializing Registration
Memory (page 120)
27
ELB-02 Owner's Manual
1