Connecting A Usb Device; Precautions When Using The [Usb To Device] Terminal; Using Usb Flash Drives - Yamaha Electone STAGEA ELB-02 Owner's Manual

Connecting a USB Device

You can connect a USB flash drive (sold separately) or a USB wireless LAN adaptor (sold separately) to the
[USB TO DEVICE] terminal. You can save data you've created on the instrument to the USB flash drive (pages
118, 147), or you can connect the instrument to a smart device such as iPad via wireless LAN (page 192).
Precautions when using the
[USB TO DEVICE] terminal
                       
This instrument features a built-in [USB TO
DEVICE] terminal. When connecting a USB device
to the terminal, be sure to handle the USB device
with care. Follow the important precautions below.
NOTE
For more information about the handling of USB devices, refer to
the owner's manual of the USB device.
Compatible USB devices
• USB flash drive
• USB hub
• USB wireless LAN adaptor
Other USB devices such as a computer keyboard or mouse
cannot be used.
The instrument does not necessarily support all
commercially available USB devices. Yamaha cannot
6 guarantee operation of USB devices that you purchase.
Before purchasing a USB device for use with this
instrument, please visit the following web page:
http://download.yamaha.com/
Although USB devices 1.1 to 3.0 can be used on this
instrument, the amount of time for saving to or loading
from the USB device may differ depending on the type of
data or the status of the instrument.
NOTE
The rating of the [USB TO DEVICE] terminal is a maximum of 5V/
500mA. Do not connect USB devices having a rating above this,
since this can cause damage to the instrument itself.
Connecting USB devices
When connecting a USB device to the [USB TO DEVICE]
terminal, make sure that the connector on the device is
appropriate and that it is connected in the proper direction.
NOTICE
• When connecting a USB device to the [USB TO DEVICE]
terminal on the top panel, remove it before closing the key
cover (if you use the separately sold key cover). If the key
cover is closed with the USB device connected, the USB
device may be damaged.
• Avoid connecting or disconnecting the USB device during
playback/recording and file management operations (such
as Save, Copy, Delete and Format), or when accessing the
USB device. Failure to observe this may result in
"freezing" of the operation of the instrument or corruption
of the USB device and the data.
• When connecting then disconnecting the USB device (and
vice versa), make sure to wait a few seconds between the
two operations.
132
ELB-02 Owner's Manual
NOTE
• If you intend to connect two or three devices at the same time
to a terminal, you should use a self-powered USB hub. Only
one USB hub can be used. If an error message appears while
using the USB hub, disconnect the hub from the instrument,
then turn on the power of the instrument and re-connect the
USB hub.
• When connecting a USB cable, make sure that the length is
less than 3 meters.
• Do not connect an extension cable.

Using USB Flash Drives

                       
By connecting the instrument to a USB flash drive,
you can save data you've created to the connected
device, as well as read data from the connected
device.
Maximum number of USB flash drives
allowed
Up to two USB flash drives can be connected to the [USB
TO DEVICE] terminal. (If necessary, use a USB hub. The
number of USB flash drives that can be recognized
simultaneously with musical instruments even when a USB
hub is used is a maximum of four.)
Formatting a USB Flash Drive
You should format the USB flash drive only with this
instrument (page 133). A USB flash drive formatted on
another device may not operate properly.
NOTICE
The format operation overwrites any previously existing
data. Make sure that the USB flash drive you are formatting
does not contain important data. Proceed with caution,
especially when connecting multiple USB flash drive.
To protect your data (write-protect)
To prevent important data from being inadvertently erased,
apply the write-protect provided with each USB flash drive.
If you are saving data to the USB flash drive, make sure to
disable write-protect.
Turning off the instrument
When turning off the instrument, make sure that the
instrument is NOT accessing the USB flash drive by
playback/recording or file management (such as during
Save, Copy, Delete and Format operations). Failure to do so
may corrupt the USB flash drive and the data.