Yamaha Electone STAGEA ELB-02 Owner's Manual page 203

3
Mount the Sideboards onto the Pedalboard
unit.
Be sure not to confuse the Right and Left
Sideboards.
3-1
Untie (at three points) and straighten out the
bundled pedal cord.
3-2
Raise the Pedalboard as shown in the illustration
below.
3-3
Position each screw hole on both the Pedalboard
and Sideboards as shown in the illustration and
mount the Sideboards onto the Pedalboard using
four screws (B; two screws on each Sideboard).
3-4
Stand the Pedalboard after securing the screws.
4
Mount the Speaker Unit onto the
Sideboards.
4-1
Remove the Grill Net from the Speaker Unit.
4-2
With the help of another person, hold the Speaker
unit horizontally, and slide it from the rear into
place along the brackets.
CAUTION
Take care not to drop the Speaker unit or to pinch your
finger(s) between the Speaker unit and Sideboard.
4-3
Push the Sideboard
toward the Pedalboard
5
B
6
6-1
While holding the Sideboard(s) to the Speaker
unit, fasten the four screws (B) from the rear, to
secure the Speaker unit to the Sideboards. Cover
the four screw holes on the rear side with the
corresponding screw caps.
Push the Sideboard
toward the Speaker unit
Screw caps
B
Affix the two cord holders to the top
surface of the Speaker unit, then insert the
Power cord in the holders as shown in the
illustration.
Make sure to place the connector of the power
cord at the front side, and the plug of the power
cord at the back side.
Clamp the holder shut
after inserting the cord.
Mount the Main Unit.
As shown in the illustration, hold the Main Unit
horizontally (with two people), and mount the Main
Unit. Be sure to place your hands at least 15 cm
from either end of the main unit when positioning it.
15 cm or further in
CAUTION
Take care not to drop the Main unit or to pinch your
finger(s) between the Speaker unit and Main unit.
Push the Sideboard
toward the Speaker unit
B
Screw
caps
203
ELB-02 Owner's Manual
1 1