Yamaha Electone STAGEA ELB-02 Owner's Manual page 205

11
Place the music rest on the Electone.
12
Turn on the Electone's [P](Standby/On)
switch and confirm that the Electone can
be played, and that the assembly is
successful.
BENCH ASSEMBLY
Turn the bench board over and put the legs in place, one by
one, at the corners of the bench board, then tighten each
nut using the included wrench. Be sure to put the washer
between each leg and nut as shown.
Leg
Washer
Nut
Bench
board
After completing the assembly, please
check the following items.
• Are there any parts left over?
→ Review all assembly procedures.
• Is the Electone clear of doors and other
movable fixtures?
→ Move the Electone to an appropriate location.
• Does the Electone make a rattling noise when
you shake it?
→ Tighten all screws.
• Can the Electone be turned on?
→ Confirm that the power cord plug is securely
connected to an appropriate power outlet.
• Does the Electone produce sounds?
→ How to produce sounds is described in "Quick
Introductory Guide. " Confirm that the Speaker cord
connector and the Pedalboard cord connector are
securely connected to each socket on the Main unit.
When moving the instrument
CAUTION
When moving the instrument, always hold the bottom of
the main unit. Do not hold the top portion. Improper
handling can result in damage to the instrument or
personal injury.
Do not hold here.
Hold here.
• Transporting
If you move to another location, you can transport the
instrument along with other belongings. You can move the
unit as it is (assembled), or you can disassemble the unit
down to the condition it was in when you first took it out of
the box. Transport the keyboard horizontally. Do not lean it
up against a wall or stand it up on its side. Do not subject
the instrument to excessive vibration or shock. When
transporting the assembled instrument, make sure all
screws are properly tightened and have not been loosened
by moving the instrument.
CAUTION
If the main unit creaks or is otherwise unsteady when
you play on the keyboard, refer to the assembly
diagrams and retighten all screws.
205
ELB-02 Owner's Manual
1 1