Avaya 4500 Series Installation Manual page 47

Important:
Avaya Ethernet Routing Switch 4500 Series only supports the Avaya CLI, the old 'Bay Stack'
menu interface is not supported on this product. When the switch is set to factory default
parameters, the CLI Quickstart appears which enables you to set default IP information.
Setting IP parameters using the console port and CLI
If the switch is configured beyond factory default settings, perform the following procedure to
set IP parameters using the console port and Command Line Interface (CLI):
1. Connect a terminal to the console port of the switch. You can use a terminal or PC
2. Set the terminal protocol on the terminal or terminal emulation program to VT100
3. Connect to the switch using the terminal or terminal emulation application.
Installation
Set IP parameters for the Avaya Ethernet Routing Switch 4500 Series
Please provide the Default Gateway[0.0.0.0]:10.127.232.1
The Read-Only Community String prompt line appears
Please provide the Read-Only Community
String[**********]:******
The confirm Read-Only Community String prompt line appears
Please confirm the Read-Only Community
String[**********]:******
The Read-Write Community String prompt line appears
Please provide the Read-Write Community
String[**********]:*******
The confirm Read-Write Community String prompt line appears
Please confirm the Read-Write Community
String[**********]:*******
The Quick Start VLAN prompt line appears
Please provide the Quick Start VLAN <1-4094> [1]:
The Basic Switch parameters configuration confirmation appears
Basic switch parameters have now been configured and saved.
with an appropriate terminal emulator as the management station. See
parameters using the console port and CLI Quickstart
or VT100/ANSI.
Setting IP
on page 45.
November 2010 47