Session - Cisco catalyst 3750 Command Reference Manual

Chapter 2 Catalyst 3750 Switch Cisco IOS Commands

session

Use the session privileged EXEC command on the stack master to access a specific stack member or to
access the controller on a Catalyst 3750G Integrated Wireless LAN Controller Switch.
Syntax Description stack-member-number
processor 1
Defaults
No default is defined.
Command Modes
Global configuration
Command History Release
12.1(11)AX
12.2(25)FZ
Usage Guidelines
When you access the member, its member number is appended to the system prompt.
Use the session command from the master to access a member switch.
Use the session command with processor 1 from the master or a standalone switch to access the internal
controller. A standalone switch is always member 1.
Use the processor 1 keyword to change to the controller command-line interface. See the
LAN Controller Configuration Guide Release 4.0
Examples
This example shows how to access member 6:
Switch(config)# session 6
Switch-6#
This example shows how to access the controller on member 2, which is a Catalyst 3750G wireless LAN
controller switch (standalone or stack master):
Switch# session 2 processor 1
(Cisco Controller)
User:
OL-8552-07
session stack-member-number [processor 1]
Modification
This command was introduced.
The processor keyword was added for Catalyst 3750G Integrated Wireless
LAN Controller Switch.
Specify the member number. The range is 1 to 9.
(Optional) Specify the destination processor for the session, that is, the
embedded controller in the Catalyst 3750G Integrated Wireless LAN
Controller Switch. Entering this keyword puts you in the controller CLI.
This keyword applies only to a wireless LAN controller switch.
Note
for controller configuration information.
Catalyst 3750 Switch Command Reference
session
Cisco Wireless
2-475