Cisco catalyst 3750 Command Reference Manual page 685

Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
show mac address-table static
Use the show mac address-table static user EXEC command to display only static MAC address table
entries.
Syntax Description address mac-address
interface interface-id
vlan vlan-id
| begin
| exclude
| include
expression
Command Modes User EXEC
Command History Release
12.1(11)AX
12.1(19)EA1
Usage Guidelines Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
OL-8552-07
show mac address-table static [address mac-address] [interface interface-id] [vlan vlan-id]
[ | {begin | exclude | include} expression]
(Optional) Specify a 48-bit MAC address; the valid format is H.H.H
(available in privileged EXEC mode only).
(Optional) Specify an interface to match; valid interfaces include physical
ports and port channels.
(Optional) Display addresses for a specific VLAN. The range is 1 to 4094.
(Optional) Display begins with the line that matches the expression.
(Optional) Display excludes lines that match the expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Modification
This command was introduced.
The show mac-address-table static command (with the hyphen) was
replaced by the show mac address-table static command (without the
hyphen).
show mac address-table static
Catalyst 3750 Switch Command Reference
2-655