Debug Matm Move Update - Cisco catalyst 3750 Command Reference Manual

debug matm move update

debug matm move update
Use the debug matm move update privileged EXEC command to enable debugging of MAC
address-table move update message processing.
Syntax Description This command has no arguments or keywords.
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.2(25)SED
Usage Guidelines The undebug matm move update command is the same as the no debug matm move update command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
canalso use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands Command
mac address-table
move update
transmit}
show debugging
show mac
address-table move
update
Catalyst 3750 Switch Command Reference
B-26
debug matm move update
no debug matm move update
Modification
This command was introduced.
Description
Configures MAC address-table move update feature on the switch.
{receive |
Displays information about the types of debugging that are enabled.
Displays the MAC address-table move update information on the switch.
Appendix B Catalyst 3750 Switch Debug Commands
OL-8552-07