Cisco catalyst 3750 Command Reference Manual page 60

authentication host-mode
This example shows how to enable single-host mode on a port:
Switch(config)# authentication host-mode single-host
You can verify your settings by entering the show authentication privileged EXEC command.
Related Commands Command
authentication
control-direction
authentication event
authentication
fallback
authentication open
authentication order
authentication
periodic
authentication
port-control
authentication
priority
authentication timer
authentication
violation
show authentication
Catalyst 3750 Switch Command Reference
2-30
Description
Configures the port mode as unidirectional or bidirectional.
Sets the action for specific authentication events.
Configures a port to use web authentication as a fallback method for clients
that do not support IEEE 802.1x authentication
Enables or disable open access on a port.
Sets the order of authentication methods used on a port.
Enables or disable reauthentication on a port.
Enables manual control of the port authorization state.
Adds an authentication method to the port-priority list.
Configures the timeout and reauthentication parameters for an
802.1x-enabled port.
Configures the violation modes that occur when a new device connects to a
port or when a new device connects to a port after the maximum number of
devices are connected to that port.
Displays information about authentication manager events on the switch.
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
OL-8552-07