Errdisable Recovery - Cisco catalyst 3750 Command Reference Manual

errdisable recovery

errdisable recovery
Use the errdisable recovery global configuration command to configure the recover mechanism
variables. Use the no form of this command to return to the default setting.
Syntax Description
cause
all
bpduguard
arp-inspection
channel-misconfig
dhcp-rate-limit
dtp-flap
gbic-invalid
inline-power
l2ptguard
link-flap
loopback
pagp-flap
psecure-violation
security-violation
sfp-mismatch
udld
Catalyst 3750 Switch Command Reference
2-186
errdisable recovery {cause {all | arp-inspection | bpduguard | channel-misconfig |
dhcp-rate-limit | dtp-flap | gbic-invalid | inline-power |l2ptguard | link-flap | loopback |
pagp-flap | psecure-violation | security-violation | sfp-mismatch | udld | vmps} | {interval
interval}
no errdisable recovery {cause {all | arp-inspection | bpduguard | channel-misconfig |
dhcp-rate-limit | dtp-flap | gbic-invalid | inline-power | l2ptguard | link-flap | loopback |
pagp-flap | psecure-violation | security-violation | sfp-mismatch | udld | vmps} | {interval
interval}
Enable the error-disabled mechanism to recover from a specific cause.
Enable the timer to recover from all error-disabled causes.
Enable the timer to recover from the bridge protocol data unit (BPDU) guard
error-disabled state.
Enable the timer to recover from the Address Resolution Protocol (ARP)
inspection error-disabled state.
Enable the timer to recover from the EtherChannel misconfiguration
error-disabled state.
Enable the timer to recover from the DHCP snooping error-disabled state.
Enable the timer to recover from the Dynamic Trunking Protocol (DTP) flap
error-disabled state.
Enable the timer to recover from an invalid Gigabit Interface Converter
(GBIC) module error-disabled state.
Note
Enable error detection for inline-power.
Enable the timer to recover from a Layer 2 protocol tunnel error-disabled
state.
Enable the timer to recover from the link-flap error-disabled state.
Enable the timer to recover from a loopback error-disabled state.
Enable the timer to recover from the Port Aggregation Protocol (PAgP)-flap
error-disabled state.
Enable the timer to recover from a port security violation disable state.
Enable the timer to recover from an IEEE 802.1x-violation disabled state.
Enable error detection on an SFP configuration mismatch.
Enable the timer to recover from the UniDirectional Link Detection (UDLD)
error-disabled state.
Chapter 2
This error refers to an invalid small form-factor pluggable (SFP)
error-disabled state.
Catalyst 3750 Switch Cisco IOS Commands
OL-8552-07