Cisco catalyst 3750 Command Reference Manual page 778

snmp-server enable traps
dot1x [auth-fail-vlan |
guest-vlan |
no-auth-fail-vlan |
no-guest-vlan]
entity
envmon [fan |
shutdown | status |
supply | temperature]
errdisable
[notification-rate
value]
flash [insertion |
removal]
fru-ctrl
hsrp
ipmulticast
mac-notification
msdp
Catalyst 3750 Switch Command Reference
2-748
(Optional) Enable IEEE 802.1x traps. The keywords have these meanings:
auth-fail-vlan—(Optional) Generate a trap when the port moves to the
•
configured restricted VLAN.
guest-vlan—(Optional) Generate a trap when the port moves to the
•
configured guest VLAN.
no-auth-fail-vlan—(Optional) Generate a trap when a port tries to enter
•
the restricted VLAN, but cannot because the restricted VLAN is not
configured.
no-guest-vlan—(Optional) Generate a trap when a port tries to enter the
•
guest VLAN, but cannot because the guest VLAN is not configured.
Note When the snmp-server enable traps dot1x command is entered
(without any other keywords specified), all the IEEE 802.1x traps are
enabled.
(Optional) Enable SNMP entity traps.
Optional) Enable SNMP environmental traps. The keywords have these
meanings:
• fan—(Optional) Enable fan traps.
shutdown—(Optional) Enable environmental monitor shutdown traps.
•
status—(Optional) Enable SNMP environmental status-change traps.
•
supply—(Optional) Enable environmental monitor power-supply traps.
•
temperature—(Optional) Enable environmental monitor temperature
•
traps.
(Optional) Enable errdisable traps. Use notification-rate keyword to set the
maximum value of errdisable traps sent per minute. The range is 0 to 10000;
the default is 0 (no limit imposed; a trap is sent at every occurrence).
(Optional) Enable SNMP FLASH notifications. The keywords have these
meanings:
insertion—(Optional) Generate a trap when a switch (flash) is inserted into
a stack, either physically or because of a power cycle or reload.
removal—(Optional) Generate a trap when a switch (flash) is removed from
a stack, either physically or because of a power cycle or reload.
(Optional) Generate entity field-replaceable unit (FRU) control traps. In the
stack, this trap refers to the insertion or removal of a switch in the stack.
(Optional) Enable Hot Standby Router Protocol (HSRP) traps.
(Optional) Enable IP multicast routing traps.
(Optional) Enable MAC address notification traps.
(Optional) Enable Multicast Source Discovery Protocol (MSDP) traps.
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
OL-8552-07