Configuration Menu - Pentair AK110 Installation And User Manual

Table of Contents

To clear the Total, for any switch place the cursor on Clear

and press ENTER .

When entering pulses per gallon the Controller will only

update this measurement once every 10 seconds.

The Configuration Menu consists of the following:

•

Name: Sets up the name of your aquatic system for easy

identification during communication and on the wireless

data management system . See pages 56 for Controller

Name Navigation Menu Tree .

•

System: Sets up time, date, weekday, and unit display

(English or Metric) . See pages 58 or System Set-up Screen

Navigation .

•

Programming: Relay programming for Relays 1, 2, 3, Alarm, and Pagers. See Programming

Section for details . See pages 52-109 for Programming Set-up Menus .

•

Service: Clear calibrations, data, or relay timers as part of normal service operations.

•

Data: Sensor readings are recorded at a default 2 hours into data. A total of 441 lines of data can be

stored . Press the down arrow key to view data . See page 114 for Data Screen Navigation .

•

Communications: Set up modems, pager numbers and or email addresses. See pages 102-105 for

Programming Screen Navigation Pager 1 . See page 116 for Communications Screen for Dail-up and

Internet Modems . See pages 106 for Programming Screen Navigation Email .

•

Security Setup: Sets up passwords, clears passwords, and resets all settings to factory defaults.

See pages 126 for Security Setup Screen Naviagtions .

•

Wizards: Select pre-written programs for common Controller applications.

See pages 110 for Wizards Setup Screen Navigation .

•

Serial #: View the serial number here. The serial number is required when requesting support.

Flow Switch 2 Setup, Clear Counter

Note: