When leaving an editing screen you will need to confirm the changes by pressing "9" or cancel by pressing press "7" .
Also after making any changes be sure to press the "Back" button until you reach the main menu screen . Otherwise your
changes will not be saved .
The following list shows all the "Wizards" available with the Controller:
Control options for pH Relay 1
1.
pH, Mix Time – use to control a pH feed system.
2.
pH, Cycle Time – use to control a pH feed system.
3.
Not Used – use to disable this relay
Control options for ORP/PPM Relay 2
1.
ORP/PPM, Mix Time – use to control a sanitizer feed system.
2.
ORP/PPM, Cycle Time – use to control a sanitizer feed system.
3 .
ORP, Cal Hypo - use to control Cal Hypo feed system
4 .
Not Used - select to disable this relay .
5.
PPM, Mix time - use the calculated PPM features
6 .
PPM, Cycle time, use the calculated PPM features
Control options for Relay 3
1 .
Not Used - select to disable this relay .
2 .
Probe Clean - use to introduce acid for a short time to clean sensors .
3.
Heater - Used to control temperature with an external heater.
4.
Alarm Out - external alarm control.
5.
pH, Mix Time - used for additional pH control (i.e. when both Acid and Base are needed.
6 .
pH, Cycle Time - optional method see program .
7 .
AUX: Make UP - control a make-up water system (auto fill) .
8 .
Daily - turns on relay once per day
9 .
Weekly - turns on relay once per day on selected day(s) of the week .
10. ORP/PPM Mix Time - use for additional sanitizer control
(i .e . when a liquid feed system is used to back up a salt generator) .
11 .
ORP/PPM, Cycle Time - optional method see program .
Control options for Pager/Email 1-4
1 .
Pager 1-4/Email 1-4
2 .
Not Used
See page 110 for the AK110 Wizards Setup Screen Navigation
38
ACU-TROL
AK110 Chemical Controller Installation and User's Guide
®
Wizards