Section 2 Installation; Installation Preparation; Installation Summary - Pentair AK110 Installation And User Manual

Inspection: Upon receiving the Controller check the carton carefully .
Report any shipping damage to shipping company. Examine the enclosed shipping list and verify that all items are
present . Contact Customer Support (800) 831 .7133 if any items are missing or have been damaged . Use care when
unpacking equipment to avoid damage or loss of small parts . Verify that the fuses are the correct values and that the
voltage select switch is in the proper position .
The following steps are required to install the Controller:
1. Identify new and existing equipment to be connected.
2 . Decide if the sensors will be in-line, in a separate by-pass line, or if the AK1200 flow cell will be used .
Caution: If the AK1200 flow cell is used, the input water maximum pressure is 25 PSI.
3 . Determine the supply voltage, 110 VAC or 220 VAC, and set the supply voltage switch as necessary .
4 . Determine if the control to the equipment uses the same voltage as the supply voltage .
All controlled equipment must be compatible .
5 . Determine the water-tap points for the flow cell bypass inlet and outlet .
6 . Mount the Controller away from direct sunlight and on a flat vertical surface .
7 . Connect the supply voltage with main breaker off . (Must be a separate dedicated circuit GFCI) .
8 . If using an AK1200 flow cell install the bypass now .
9 . Connect the sensors .
10 . Test the plumbing for leaks .
11 . Turn on the Controller for the first time .
12 . Test the equipment, using the Controller manual relay mode .
13 . Calibrate the probes, then re-calibrate as the probes acclimate to the system .
Acclimation can take as little as two hours or as long as 24 hours .
14 . Program the Controller .
15. Call or visit the controller over the next few days to insure the system is balanced and in control.
Fine-tune the setup if necessary .
8
ACU-TROL AK110 Chemical Controller Installation and User's Guide
®
SECTION 2
INSTALLATION

Installation Preparation

Installation Summary