Start Up; Initializing The Controller; Power Up Screen - Pentair AK110 Installation And User Manual

The following steps need to be performed to properly setup the Controller:
1 . Perform any required calibrations .
2. Decide to use mixing time control or cycle time control.
3 . Set up the timing parameters based on the size of the water and chemical feeding system .
4 . If the AKRTC (Real Time Clock) module is installed set the time, date and weekday . (Part # 724000280)
5 . Set the overfeed time limits in programming .
6 . Return as needed to recalibrate any changes to the settings
7 . If the AK540 modem (Part# 725000010) is installed, then set the number
of rings to answer on and setup the paging conditions .
Initializing the AK110PS Pool and Spa Chemical Controller
During power-up the Controller will display the Power Up Screens for a few seconds before defaulting to the Display
Screen . During this Power On Self Test mode, the Controller will perform a brief check of its internal systems and
initialize the internal (RAM) memory for Controller operation. Next the Controller will auto detect for the various
installed modules and indicate which ones are detected . The opening screen includes the software version number and
will be required when requesting support . When turning on a number will be displayed in the lower left corner of the
display screen indicating how many seconds until control will actually start . This is to allow time for the sensor readings
to stabilize .
Display Screen: Displays measurements of connected sensors and also relay status . To the right of the Sensor read-
ings are also displayed the set point values . To change set points you will need to go to programming and change them
there . Pressing the Up Arrow key when the curser is at the top of the readings screen will move you back to the opening
screen .
26
ACU-TROL AK110 Chemical Controller Installation and User's Guide
®

Start Up

Power Up Screens
Display Screen