Relay Time Display; Setup Flow - Pentair AK110 Installation And User Manual

The Relay Timer display indicates the present status of the 8 timers
used in the Controller . The most common use for this screen is to
perform diagnostics on a specific relay or to see how long a relay
has been on . From the DISPLAY SCREEN press the right arrow button
twice . Press the left arrow button to return to readings screen .
Note: To reset the relay timers to zero use the right button to scroll the cursor beside the information that you want to
reset and then press the ENTER button .
• TMR: Displays relay timer. Shows time remaining for relay on time.
This timer will be counting with off and on cycles . Counting down when ON cycle, counting up when OFF cycle .
• TD: Displays the time the MPS has been ON for the current day (ToDay).
• CNT: Total number of relay cycles since last reset.
• S: Set overfeed timer, length of relay on time without reaching set point.
• STS: Status of relay ON, OFF, Set Point Overfeed(SOV), Overfeed(OVF), and Disable (DIS).
• TOT: Displays the total time the MPS has been ON since last reset in hours:minutes.
To use a switch as a digital flow switch you must first set it up . To enter the setup screen from the DISPLAY SCREEN
move the cursor to the switch "SW_" to be setup and press ENTER . You can enter the number of pulses per gallon from
1 to 999 .9 . This second method should only be used for flow meters that generate less than one pulse per gallon .
The highest volume that can be accumulated from the flow rate is 65,535 gallons .
Flow can also be displayed in g/pul and Piezo .
NOTE: Switch 1 is the default flow switch for relay control and should not be used for digital flow if switch 2 is
available.
Flow Switch 2 Setup
Flow Switch #2
SW2 K => 8.5 pul/g
g/m =
Total = 256
NOTE: If k = 0 than g/m = and Total = will not be displayed on the screen.
30
ACU-TROL AK110 Chemical Controller Installation and User's Guide
®
RELAY TIMER DISPLAY
35
Clear
Timer Screen, Relay 1 (pH)
pH, Mix TMR00:00:00
CNT:
STS:OFF TOT 0:00

SETUP FLOW

>TD00:00:00
0 S 00:00:00