Table of Contents
Advertisement
Access to restricted access mode 'Install'
Speedeo Connect controls the equipment in the technical room, and the wrong settings may have serious
consequences for the safety of the pool. Because of this, access to certain initial configuration functions
is reserved for professionals, or people whose experience enables them to modify these parameters while
SPEEDEO® Connect
P O O L
0 1: 03 E au :+2 4 . 3° C
01:03 Eau:+24.3°C
F il tr at ion : V2
Filtration: V2
S1 :O FF S 2: ON S 3 :O F F
S1:OFF S2:ON S3:OFF
AI R: +2 5. 9°C
AIR:+25.9°C
Menu organisation / Heating menu / Information menu
16:03
Water:+26.3°C *
Filtration: ON
RedOx: 061mV
Air:+25.0°C
pH: 7.2
-Mode
: Californian
Choice between 14 lighting
modes
-Heating pump
Calibration
Antifreeze : +3°C
Below this temperature, the filtration runs 24/7 to prevent the pool from freezing (active wintering).
- If the air temperature probe is connected: it becomes the reference value for freeze protection management. Place it outdoors,
out of direct sunlight so that the measurements are not distorted (see p06). - If the air temperature probe is not connected: the
water temperature becomes the reference value for freeze protection management. Please check that the technical room is not heated
or has a significantly different temperature in comparison with the temperature outside. If this is the case, the difference must be
compensated by Calibration.
15
AUTO M AT I O N
SYSTE M
*
VALID
-Filtration time
Filtration speed
Filter backwash
Inputs
Outputs
-Setting the time
Temperatures
Information
Languages
Update
Radio
Lighting
Local pairing
Cloud Connection
-LANGUAGE : French
Choice between French and
English
-Heating pump: AUTO
Set point
Priority
CALIBRATION
-Temp. Water:+23.2°C
-Temp. Air
being fully aware of the consequences. In order to limit accidental
access, the Install menu menu has secured access. (from the main
menu, simultaneously hold down Esc and Valid for 3 secs. A star
appears in the top right corner of the home screen).
*
The Install menu menu is active.
It automatically deactivates after 15 mins of inactivity.
See p17 (this menu no longer exists if a SOLEO is paired)
See p17
See p 24
See p18 (accessed through Install)
See p19 (accessed through Install)
See p17 (this menu no longer exists if a SOLEO is paired)
See p28 (accessed through Install)
See p10
See p25
AUTO Activate the heating pump until the set point value has been
: 30°C
reached. Priority: NO Make sure the heating pump does not start
: NO
until the filtration is already running. Priority: YES Start filtration
so that the heating can function.
This setting makes it possible to deliberately correct any difference
:+23.3°C
with another reference thermometer.
Speedeo Connect
Version : X.X
pentairpooleurope.com
Informs about the version of
the OS
Advertisement
Table of Contents
