Mitsubishi Electric MR-J4 Instruction Manual page 179

5. PARAMETERS
No. Symbol
PC10 MOD2 Analog monitor 2 output
Select a signal to output to MO2 (Analog monitor 2). Refer to appendix 11 (3) for detection
point of output selection.
Setting
digit
_ _ x x
_ x _ _
x _ _ _
PC11 MO1 Analog monitor 1 offset
This is used to set the offset voltage of MO1 (Analog monitor 1).
PC12 MO2 Analog monitor 2 offset
This is used to set the offset voltage of MO2 (Analog monitor 2).
PC13 MOSDL Analog monitor - Feedback position output standard data - Low
Set a monitor output standard position (lower 4 digits) for the feedback position for when
selecting "Feedback position" for MO1 (Analog monitor 1) and MO2 (Analog monitor 2).
Monitor output standard position = [Pr. PC14] setting × 10000 + [Pr. PC13] setting
PC14 MOSDH Analog monitor - Feedback position output standard data - High
Set a monitor output standard position (higher 4 digits) for the feedback position for when
selecting "Feedback position" for MO1 (Analog monitor 1) and MO2 (Analog monitor 2).
Monitor output standard position = [Pr. PC14] setting × 10000 + [Pr. PC13] setting
PC17 **COP4 Function selection C-4
This is used to select a home position setting condition.
Setting
digit
_ _ _ x
_ _ x _
_ x _ _
x _ _ _
PC18 *COP5 Function selection C-5
This is used to select an occurring condition of [AL. E9 Main circuit off warning].
Setting
digit
_ _ _ x
_ _ x _
_ x _ _
x _ _ _
Name and function
Explanation
Analog monitor 2 output selection
Refer to [Pr. PC09] for settings.
For manufacturer setting
Explanation
Selection of home position setting condition
0: Need to pass servo motor Z-phase after power on
1: Not need to pass servo motor Z-phase after power on
Linear encoder multipoint Z-phase input function selection
When two or more reference marks exist in the fully stroke, set "1".
0: Disabled
1: Enabled
This parameter is used by servo amplifier with software version A5
or later.
For manufacturer setting
Explanation
For manufacturer setting
[AL. E9 Main circuit off warning] selection
0: Detection with ready-on and servo-on command
1: Detection with servo-on command
5 - 38
Initial
Setting
value
range
[unit]
Refer to the
"Name and
function" column.
Initial
value
01h
0h
0h
0 -999 to
[mV] 999
0 -999 to
[mV] 999
0 -9999 to
[pulse] 9999
0 -9999 to
[10000 9999
pulses]
Refer to the
"Name and
function" column.
Initial
value
0h
0h
0h
0h
Refer to the
"Name and
function" column.
Initial
value
0h
0h
0h
0h