Response Of Digital Outputs To Faults Or Simatic Stop; Substitute Value For Dq 0, 1, 2, 3 Following Fault Or Simatic Stop - Siemens SIWAREX WP241 Manual

8.9.4

Response of digital outputs to faults or SIMATIC STOP

This parameter allows you to define the response of the digital outputs following a fault of the
SIWAREX module or SIMATIC STOP.
Value
0
1
2
3
8.9.5

Substitute value for DQ 0, 1, 2, 3 following fault or SIMATIC STOP

The outputs are usually reset following a module fault (operating error) or SIMATIC CPU
STOP. This response is the default setting.
If an output is to be set following a fault, this response is defined using this parameter. The
"Response of digital outputs to fault or SIMATIC STOP" parameter must also be set to
"Output substitute value".
The substitute value definition is then valid.
Examples
Table 8- 6
Value of bit 0
0
1
Table 8- 7
Value of bit 1
0
1
NOTICE
Risk to the plant
If an output is set following a fault (operating error), this can pose a risk for the plant.
Ensure that the parameters are correctly set.
SIWAREX WP241
Manual, 04/2014, A5E33713528A
Response
Outputs are switched off
Outputs are not switched off (continue)
The relevant substitute value is activated
Outputs are switched on
Bit 0 defines digital output 0 (DQ.0)
Bit 1 defines digital output 1 (DQ.1)
Scale parameters and functions of the belt scale
8.9 DR 7 Process interfaces
Value of DQ.0 following fault
0
1
Value of DQ.1 following fault
0
1
101