Siemens SIWAREX WP241 Manual page 149

Command Command
code
65 Start span calibration by
test chain
67 Start span calibration
using material batch
68 Stop span calibration using
material batch
69 Calculate span calibration
point after material batch
70 Start speed/pulse
detection
71 Stop speed/pulse
detection
72 Start speed measurement
"belt loaded"
73 Stop speed measurement
"belt loaded"
74 Enable belt revolution
detection on DI.1
79 Abort running
calibration/zeroing/belt
detection/speed
measurement
81 Multiply a x b
83 Divide a / b
SIWAREX WP241
Manual, 04/2014, A5E33713528A
Description
Start of span calibration with a test chain. The load value is specified in data
record 3. The span of the scale characteristic is determined for the
parameterized number of belt revolutions. The result is initially entered in DR4
and can then be imported into DR3 using command 89.
Command 67 must be sent before the material defined in data record 3
reaches the measuring point.
Command 68 must be sent after the material defined in data record 3 has
completely passed the measuring point.
Command 69 can be used after the commands 67 and 68 to calculate the
span calibration point. The result is initially entered in DR4 and can then be
imported into DR3 using command 89.
The command is used in the case of belt scales without speed sensor to start
determination of the belt speed, or in the case of belt scales with speed sensor
to start calculation of the pulse constants. The basis in each case is an exactly
specified belt length in DR3. The command should be sent at the moment
when a belt marking passes a defined point.
The command is used in the case of belt scales without speed sensor to stop
detection of belt speed, or in the case of belt scales with speed sensor to stop
calculation of the pulse constants. The command should be sent at the
moment when a belt marking passes a defined point. The result is initially
entered in DR4 and can then be imported into DR3 using command 85. The
defined number of belt revolutions in DR3 must be observed!
The command can be used in the case of belt scales without speed sensor in
order to start the speed measurement with the belt loaded (preferably with
nominal belt load). The command should be sent at the moment when a belt
marking passes a defined point.
The command can be used in the case of belt scales without speed sensor in
order to stop the speed measurement with the belt loaded (preferably with
nominal belt load). The command should be sent at the moment when a belt
marking passes a defined point. The result (speed and average belt load in
percent) is initially entered in DR4 and can then be imported into DR3 using
command 86. The defined number of belt revolutions in DR3 must be
observed!
If a proximity switch is used to detect the belt revolutions (digital input DI.1
must be parameterized for this purpose in DR7), detection of the switch signal
must first be released using command 74. Totalizing is then stopped, and the
module waits for the switch signal at the digital input in order to start the belt
revolution detection. The module then expects pulses from the switch at DI.1.
For example, 3 pulses are expected if 3 belt revolutions were specified in DR3.
Detection of the belt revolution is complete following the third pulse. The result
is initially entered in DR4 and can then be imported into DR3 using command
85.
All generated dynamic commands are aborted.
The numbers A and B from DR21 are multiplied together. The result is entered
in DR4.
The numbers A and B from DR21 are divided by each other. The result is
entered in DR4.
Command lists
10.2 Command lists
149