Check
5.15 Power Module Check
Check No.22
Note:
Check to make sure that the voltage between (+) and (–) of the power module is approx. 0 V before
checking.
Disconnect the compressor harness connector from the outdoor unit PCB. To disengage the
Follow the procedure below to measure resistance between the terminals of the power module
Negative (–) terminal of
tester (positive terminal
(+) for digital tester)
Positive (+) terminal of
tester (negative terminal
(–) for digital tester)
Resistance is OK.
Resistance is NG.
09/12 class
153
connector, press the protrusion on the connector.
and the terminals of the compressor with a multi-tester. Evaluate the measurement results
referring to the following table.
Power module
UVW
(+)
UVW
Power module
(+)
several k ~ several M
0 or
Power module
UVW
(–)
UVW
Power module
Power module
(R16069)
Service Diagnosis
SiUS091133
(–)