Traffic Storm Control Example Configuration; Default Settings - Cisco nexus 5000 series Cli Configuration Manual

Traffic Storm Control Example Configuration

S e n d f e e d b a c k t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
Traffic storm control uses a 10-microsecond interval that can affect the operation of traffic storm control.
Note
To display traffic storm control counters on an interface, perform this task:
Command
Step 1
switch# show interface [ethernet
slot/port | port-channel number]
counters storm-control
Traffic Storm Control Example Configuration
The following example shows how to configure traffic storm control:
switch# configure terminal
switch(config)# interface ethernet 1/4
switch(config-if)# storm-control broadcast level 40
switch(config-if)# storm-control multicast level 40
switch(config-if)# storm-control unicast level 40

Default Settings

Table 1-1
Table 1-1
Parameters
Traffic storm control
Threshold percentage
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
1-4
lists the default settings for traffic storm control parameters.
Default Traffic Storm Control Parameters
Chapter 1
Purpose
Displays the traffic storm control counters.
Default
Disabled
100
Configuring Traffic Storm Control
OL-16597-01