Cisco nexus 5000 series Cli Configuration Manual page 343

Chapter 1 Configuring Smart Call Home
S e n d f e e d b a c k t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
destination profile only if that Call Home alert belongs to one of the alert groups associated with that
destination profile and if the alert has a Call Home message severity at or above the message severity set
in the destination profile (see the
Table 1-1
messages generated for the alert group.
Table 1-1 Alert Groups and Executed Commands
Alert Group
Cisco-TAC
Configuration
Diagnostic
EEM
Environmental
OL-16597-01
"Call Home Message Levels" section on page
lists supported alert groups and the default CLI command output included in Call Home
Description
All critical alerts from the other alert groups
destined for Smart Call Home.
Periodic events related to configuration.
Events generated by diagnostics.
Events generated by EEM.
Events related to power, fan, and
environment-sensing elements such as
temperature alarms.
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
Information About Call Home
1-5).
Executed Commands
Execute commands based on the
alert group that originates the alert.
show module
show module fex
show running-config all
show startup-config
show version
show diagnostic result fex all
show diagnostic result module all
show diagnostic result module
number
show logging last number
show module
show module fex
show prom all
show tech-support platform
show tech-support platform
callhome
show tech-support platform
callhome fex
show version
show diagnostic result module all
show diagnostic result module
number
show module
show tech-support platform
show environment
show environment fan
show environment fex all
show environment power
show environment temperature
show logging last 1000
show module
show tech-support platform
callhome
show version
1-3