Resetting Fspf To The Default Configuration; Enabling Or Disabling Fspf; Clearing Fspf Counters For The Vsan; Fspf Interface Configuration - Cisco nexus 5000 series Cli Configuration Manual

Chapter 1 Configuring Fibre Channel Routing Services and Protocols
S e n d f e e d b a c k t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

Resetting FSPF to the Default Configuration

To return the FSPF VSAN global configuration to its factory default, perform this task:
Command
Step 1
switch# configuration terminal
switch(config)#
Step 2
switch(config)# no fspf config vsan
vsan-id

Enabling or Disabling FSPF

To enable or disable FSPF routing protocols, perform this task:
Command
Step 1
switch# configuration terminal
switch(config)#
Step 2
switch(config)# fspf enable vsan vsan-id
switch(config)# no fspf enable vsan vsan-id

Clearing FSPF Counters for the VSAN

To clear the FSPF statistics counters for the entire VSAN, perform this task:
Command
Step 1
switch# clear fspf counters vsan vsan-id

FSPF Interface Configuration

Several FSPF commands are available on a per-interface basis. These configuration procedures apply to
an interface in a specific VSAN.
This section includes the following topics:
•
•
•
•
•
•
•
OL-16597-01
About FSPF Link Cost, page 1-6
Configuring FSPF Link Cost, page 1-6
About Hello Time Intervals, page 1-6
Configuring Hello Time Intervals, page 1-6
About Dead Time Intervals, page 1-7
Configuring Dead Time Intervals, page 1-7
About Retransmitting Intervals, page 1-7
Purpose
Enters configuration mode.
Deletes the FSPF configuration for the specified
VSAN.
Purpose
Enters configuration mode.
Enables the FSPF routing protocol in the
specified VSAN.
Disables the FSPF routing protocol in the
specified VSAN.
Purpose
Clears the FSPF statistics counters for
the specified VSAN. If an interface
reference is not specified, all counters
are cleared.
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
FSPF Interface Configuration
1-5