Displaying Management Interface Configuration; Shutting Down The Management Interface - Cisco nexus 5000 series Cli Configuration Manual

Chapter 1 Configuring the Switch
S e n d f e e d b a c k t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

Displaying Management Interface Configuration

To display the management interface configuration, use the show interface mgmt 0 command.
switch# show interface mgmt0
mgmt0 is up
switch#

Shutting Down the Management Interface

To shut down the management interface (mgmt0), you use the shutdown command. A system prompt
requests you confirm your action before it executes the command. You can use the force option to bypass
this confirmation. The following example shuts down the interface without using the force option:
switch# configure terminal
switch(config)# interface mgmt 0
switch(config-if)# shutdown
Shutting down this interface will drop all telnet sessions.
Do you wish to continue (y/n)? y
The following example shuts down the interface using the force option:
switch# configure terminal
switch(config)# interface mgmt 0
switch(config-if)# shutdown force
Managing the Switch Configuration
This section includes the following topics:
•
•
•
Displaying the Switch Configuration
You can view the ASCII form of the configuration file when required. To view the current configuration
tree from the EXEC prompt, enter the show running-config command. If the running configuration is
different from the startup configuration, enter the show startup-config command to view the ASCII
OL-16597-01
Hardware is GigabitEthernet, address is 000d.ec8f.cb00 (bia 000d.ec8f.cb00)
Internet Address is 172.16.131.202/24
MTU 1500 bytes, BW 0 Kbit, DLY 0 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA
full-duplex, 1000 Mb/s
Input flow-control is off, output flow-control is off
8540 packets input, 2835036 bytes
5202 multicast frames, 0 compressed
0 input errors, 0 frame, 0 overrun, 0 fifo
570 packets output, 85555 bytes
0 underrun, 0 output errors, 0 collisions
0 fifo, 0 carrier errors
Displaying the Switch Configuration, page 1-21
Saving a Configuration, page 1-22
Clearing a Configuration, page 1-22
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
Managing the Switch Configuration
1-21