Managing Cfs Regions; Assigning Applications To Cfs Regions - Cisco nexus 5000 series Cli Configuration Manual

Chapter 1 Using Cisco Fabric Services
S e n d f e e d b a c k t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

Managing CFS Regions

This section describes how to manage a CFS region. A set of commands are used to complete the
following tasks:
•
•
•
•
•
Creating CFS Regions
To create a CFS region, perform this task:
Command
Step 1
switch# configure
switch(config)#
Step 2
switch(config)# cfs region region-id

Assigning Applications to CFS Regions

To assign an application on a switch to a region, perform this task:
Command
Step 1
switch# configure
switch(config)#
Step 2
switch(config)# cfs region region-id
Step 3
switch(config-cfs-region)# ntp
switch(config-cfs-region)# callhome
Moving an Application to a Different CFS Region
To move an application for example, from Region 1 (originating region) with NTP and Call Home
applications assigned to it, to Region 2 (target region), perform this task:
Command
Step 1
switch# configure
switch(config)#
Step 2
switch(config)# cfs region region-id
Step 3
switch(config-cfs-region)# ntp
switch(config-cfs-region)# callhome
If you try adding an application to the same region more than once, you see the error message,
Note
"Application already present in the same region."
OL-16597-01
Creating CFS Regions, page 1-11
Assigning Applications to CFS Regions, page 1-11
Moving an Application to a Different CFS Region, page 1-11
Removing an Application from a Region, page 1-12
Deleting CFS Regions, page 1-12
Purpose
Enters configuration mode.
Creates a region.
Purpose
Enters configuration mode.
Creates a region.
Adds application(s).
Purpose
Enters configuration mode.
Enters CFS region configuration submode.
Indicates application(s) to be moved into Region 2
that originally belong to Region 1. For example, here,
the NTP and Call Home applications are moved to
Region 2.
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
CFS Regions
1-11