Repair Procedures; Introduction; Section 4 Repair Procedures - Genie Super-Straddle Service Manual

Hide thumbs Also See for Super-Straddle:

Operator's manual (26 pages)

Operator's manual (27 pages)

Table Of Contents

Table of Contents

September 2016

Section 4

Repair Pr oc edures

Intr oducti on

Observe and Obey:



Repair procedures shall be completed by a

person trained and qualified on the repair of

this machine.



Immediately tag and remove from service a

damaged or malfunctioning machine.



Repair any machine damage or malfunction

before operating the machine.

Before Repairs Start:



Read, understand and obey the safety rules

and operating instructions in the appropriate

operator's manual on your machine.



Be sure that all necessary tools and parts are

available and ready for use.



Use only Genie approved replacement parts.



Read each procedure completely and adhere

to the instructions. Attempting shortcuts may

produce hazardous conditions.

Machine Configuration:



Unless otherwise specified, perform each

repair procedure with the machine in the

following configuration:

• Machine positioned on a firm, level surface

• Straddle frame fully lowered

• Casters locked

Part No. 115429

About This Section

Most of the procedures in this section should only

be performed by trained service professional in a

suitably equipped workshop. Select the appropriate

repair procedure after troubleshooting the problem.

Perform disassembly procedures to the point

where repairs can be completed. Then to

re-assemble, perform the disassembly steps in

reverse order.

Symbols Legend

Indicates that a specific result is expected

after performing a series of steps.

Indicates that an incorrect result has occurred

after performing a series of steps.

Super Straddle

Service Manual