Checklist C Procedures; Inspect The Wear Pads; Replace The Friction Disks - Genie Super-Straddle Service Manual

September 2016
Checklist C Procedur es
C-1 C-1 Inspec t the Wear Pads

Inspect the Wear Pads

Genie specifications require that this procedure be
performed every 1000 hours or annually,
whichever comes first.
Maintaining the wear pads in good condition is
essential to safe machine operation. Wear pads on
the Super Straddle are used to provide a uniform fit
between the end frames and straddle frame, as
well as a means to prevent wear to the frame
assemblies during the extend and retract
functions. Over time, it may be necessary to replace
the wear pads to ensure good machine
performance. Wear pads are placed on the outer
ends of the straddle frame assemblies and should
be replaced when the surface of the wear pad is
reduced by 25% or more. Continued use of worn
wear pads may result in component damage and
unsafe operating conditions.
1 Measure the wear pads. See Repair
procedure, How to Access the Wear Pads.
Part No. 115429

Checklist C Procedures

C-2 Repl ace the Friction Disk s
C-2

Replace the Friction Disks

Genie specifications require that this procedure be
performed every 1000 hours or annually,
whichever comes first.
Maintaining the winch is essential to good
machine performance and safe operation. An
unsafeworking condition exists if the winch has
excessive wear and/or does not operate smoothly,
free of hesitation and binding.
1 Replace the winch friction disks. See Repair
procedure, How to Disassemble a One-speed
Winch.
Super Straddle
Service Manual
15