Ap Navigation Panel - ZyXEL Communications wap3205 V3 User Manual

Table 12 Status Screen (AP Mode) (continued)
LABEL
- WPS
System Status
Operation Mode
System Up Time
Current Date/Time
Interface Status
Interface
Status
Rate
Summary
Client Table
Packet Statistics
Message

4.2.2 AP Navigation Panel

Use the menu in the navigation panel to configure WAP3205 v3 features in AP Mode.
The following screen and table show the features you can configure in AP Mode.
Figure 21 Menu: AP Mode
Chapter 4 Modes
DESCRIPTION
This displays Configured when the WPS (Wi-Fi Protected Setup) has been set up.
This displays Unconfigured if the WPS has not been set up.
This field shows the device operating mode: Access Point, Universal Repeater or Client
Bridge.
This is the total time the WAP3205 v3 has been on.
This field displays your WAP3205 v3's present date and time.
This displays the WAP3205 v3 port types.
For the LAN ports, this field displays Down (line is down) or Up (line is up or connected).
For the WLAN, it displays Up when the WLAN is enabled or Down when the WLAN is
disabled.
For the LAN ports, this displays the port speed or N/A when the line is disconnected.
For the WLAN, it displays the maximum transmission rate when the WLAN is enabled and
N/A when the WLAN is disabled.
Use this screen to view current client information. Click "Details..." to see the screen.
Use this screen to view port status and packet specific statistics. Click "Details..." to see
the screen.
Use this screen to view the status of the WAP3205 v3.
WAP3205 v3 User's Guide
35