Push Button Configuration (Pbc) - ZyXEL Communications wap3205 V3 User Manual

• PIN Configuration - create a secure wireless network simply by entering a wireless client's PIN (Personal
Identification Number) in the WAP3205 v3's interface. See
secure method, since one device can authenticate the other.

5.3.1 Push Button Configuration (PBC)

Make sure that your WAP3205 v3 is turned on and that it is within range of your computer.
1
Make sure that you have installed the wireless client (this example uses the NWD210N) driver and utility in
2
your notebook.
In the wireless client utility, find the WPS settings. Enable WPS and press the WPS button (Start or WPS
3
button)
Log into WAP3205 v3's Web Configurator and press Push Button in the Network > Wireless LAN > WPS
4
Station screen.
Note: Your WAP3205 v3 has a WPS/RESET button located on its back panel, as well as a WPS
button in its configuration utility. Both buttons have exactly the same function; you can
use one or the other.
Note: It doesn't matter which button is pressed first. You must press the second button within
two minutes of pressing the first one.
The WAP3205 v3 sends the proper configuration settings to the wireless client. This may take up to two
minutes. Then the wireless client is able to communicate with the WAP3205 v3 securely.
The following figure shows you an example to set up wireless network and security by pressing a button
on both WAP3205 v3 and wireless client (the NWD210N in this example).
Chapter 5 Tutorials
WAP3205 v3 User's Guide
45
Section 5.3.2 on page 46. This is the more